Forklift Battery Charger 24V 20A Smart Trickle Charger with LCD Display, 24 Volt

  
Forklift Battery Charger 24V 20A Smart Trickle Charger with LCD Display, 24 Volt 20 AMP Fully Automatic, for Lead-Acid Batteries, for Pallet Jack/Floor Scrubber/Golf Cart. 24V 20A Forklift Battery Charger. 7.6 x 5.1 x 2.8 inches. 20A 600W Charging & Fan Design & Overheating Protection?

This fully automatic smart charger is suitable for all vehicles equipped with 24V lead-acid batteries, such as forklifts, floor washers, sightseeing cars, and golf carts. The fan always runs during charging to effectively cool the charger and ensure stable operation. The operating temperature range of the 24 volt battery charger is 0? When the ambient temperature exceeds 65? , the charger will automatically shut down for protection.

Voltage and Current Display & Charging Completion Prompt? The 24 volt charger adopts constant voltage and constant current mode for intelligent charging.

The display shows "2420" to indicate that this is a 24V20A charger. When charging, the display will alternately show the charging voltage and current (the last letter "U" means "Voltage" and "R" means "Current").

After the battery is fully charged, the forklift battery charger will automatically stop output and the display will show "FULL". Fault Code Prompt and Fan Stops Working?

When the 24v charger has the following six conditions, the corresponding fault code will be displayed on the screen, the fan will stop rotating, and the charger will stop working. (1) No-load state; (2) When the connected battery pack voltage is lower than the pre-charge voltage limit; (3) When the voltage of the connected battery pack is higher than the trickle charging voltage; (4) The temperature exceeds 65°C; (5) Short circuit; (6) Reverse polarity.

Output Protection Device & Charging Time Control? During the charging process, the 24v battery charger will automatically adjust the output voltage and current. When the battery is reverse-connected and the output is short-circuited, the internal circuit of the 24v charger is disconnected from the battery and will not damage the charger.

The 24 volt charger is set with a maximum charging time (15 hours), which can effectively avoid battery damage caused by overcharging. 7.4ft Cable & Anderson Plug?

The 24v lead acid battery charger comes with a 4ft power cord, 3.4ft charging cable and battery quick connector to charge your vehicle quickly and safely. The 24 volt forklift battery charger also comes with a spare plug connector and 2 terminal pins for wider use. FCC and ETL Certification & Portable Handle? This 24v battery charger has an input voltage of AC 100-240V, has FCC and ETL certification, and can also repair batteries with vulcanized plates.

The 24v battery charger weighs 4.6 pounds and has an easy-to-carry handle on the top, so you can easily carry it anywhere. Display Charging Details and Fault Codes.

This smart charger will display the charger specification (24V20A), and then alternately display the charging voltage and current (the last letter "U" is "voltage" and "R" is "current"). The charger displays "FULL" which means the battery is fully charged. The charger is set with a maximum charging time (15 hours) before leaving the factory, which can effectively avoid battery damage caused by overcharging. Output Voltage and Current: 24V 20A. (1) This 24v battery charger is specially designed for charging lead-acid batteries and cannot be used as a general power source.

(2) After charging is complete, the AC power socket must be disconnected first, and then the battery terminal cable connector, the order cannot be changed! Shop with confidence - Thousands of happy customers trust us for quality products and fast service!