The whole process only requires to plug in the power supply, turn on the power switch and it will be charged automatically. There is no need for manual supervision throughout the whole process, and the power is automatically stopped when it is full-charged. Come with a LCD Screen for you to read the current and voltage clearly during charging process.
Three indicator lights on the panel, charging indicator, fully charge indicator, fault indicator. Equipped with high amps battery quick connector for your use. Designed with a portable handle for easy carrying. Built-in cooling fan for heat dissipation.
This device is a fully automatic intelligent fast charging device, the entire operation only needs to be plugged in and turned on the power switch to automatically charge. The whole process does not require manual monitoring, and the output will automatically stop after being fully charged. Intelligent temperature control is adopted inside the machine. The charging current can reach 30A, which is not affected by the change of the input AC voltage.Charging time is faster than traditional models, and the efficiency is twice that of traditional models; it is currently the most advanced electronic charger in China. Built-in cooling fan which can automatically dissipate heating.
Equipped with over-voltage, over-current, and over-heat protection to protect the circuit. When the grid voltage, output current, and internal temperature exceed the set standards, the machine stops working automatically to protect the machine and vehicle from damage. The AUTOOL EM160 is 3.1kg only and designed with a portable handle for carrying around. AUTOOL EM160 smart fast charger apply for forklifts, golf carts, floor scrubbers. Suitable for 24V, 200AH-300AH lead-acid battery vehicles. Step 1: firstly connect the battery connector. Step 2: then plug it into 110V power supply. Step 3: turn on the power switch. Step 4:the machine will output current and voltage after self-checking for 3-4S.Step 5:The digital display shows the current and voltage, the charging indicator light is on (red). Step 6: When the battery is fully charged, the full indicator lights (green).
Step 7:After charging is completed, turn off the power switch. Step 8: then unplug the power supply plug, and finally unplug the battery connector.Be sure to distinguish the "+" and "-" poles when using the charger machine, which is available for 24V, 200AH -300AH lead-acid batteries. Do not use the way of charging connection to start the engine, which is easy to burn out the meter and motor.
The correct sequence is to first connect the battery connector, then connect into the 110V or 220V power plug, turn on the power switch, confirm that the ground wire is connected reliably and there is no looseness, and finally connect the power plug into the power supply. The operation of the machine should be carried out in a relatively dry environment, and the air humidity should not exceed 90 % in general. The ambient temperature should be between -10? Avoid operating in strong sunlight or rain, and do not allow water or rain to seep into the machine. Avoid working in dusty areas or environments containing corrosive gases.Avoid operating in an environment with strong air flow. Avoid the entry of water or vapor into the machine, and in such cases, dry the inside. Should be put back into the original box and stored in a dry environment if not used for a long time. 1pc EM160 Fully-Automatic Smart Charger main unit.